Three hours in - and almost half way through the build - I started to realise I might be getting pretty tight to finish. It’d been all good since the gun went off but I knew I was going to speed up if I was gonna have a chance. We’d been told that our best chance of scoring well would be to get as many elements of the build completed as we could. Obviously quality was important but we couldn’t afford too long on anything. From then until the next break I worked tirelessly, it was unbelievably hot and the sweat was pouring off me. It was physically and mentally exhausting but I knew from the first break that everyone was doing it pretty tough. I got the roof done and was pretty pleased but was also very aware of how much I had to go.
I upped the pace and invariably made a few mistakes in doing so. Nothing catastrophic - but enough to slow me down as I had to go back over things twice. A good example of this was the decking boards where, to save time, I butted them up against the guard of the drop saw after I measured my first board. The problem with that was that I was a few millimetres out between boards and it didn’t look to flash. I ended up having to fix them down before scribing a line and re-cutting them all, wasting what little time I had left towards the end.
With an hour and half to go we stopped for our mandatory last break. Knowing how much I still had to go I was more than happy to cut the break to 10 minutes to get more time on the build. That last hour and half flew by and in no time at all they were counting down the last few minutes. I was rushing right up until the end and while I didn’t get it completely finished there was a huge relief to be done. It was so incredibly intense that’s it hard to explain. We then waited for the projects to be judged before we all jumped in, along with whoever else was still spectating, to get each build completed before they were taken away.